If it’s time to install a new heater in your home, the best thing to do is to hire a company that provides heater installation in Maple Grove. A qualified company can take your old heater out and install a new one in a matter of hours in some cases. Besides that, you can have peace of mind in knowing it was done right. But if you want to try to do it yourself and you have some experience, here are some of the steps to keep in mind.
Know the Tools You’ll Need
Before you begin a project as involved and intricate as replacing your furnace, you should have all of your tools gathered. You won’t want to stop in the middle of the job to go look for a tool that you need or run to the hardware store to buy one. Some of the things you’ll need include a variety of screwdrivers, a hammer, a pry bar, wrenches (including pipe wrenches) and more. Take a look at the instructions for installing your new furnace to get an idea of the tools you’ll need to get the job done.
Shut Off the Power
Some people forget that they need to shut off the power to the furnace before they start working on it. This can be a dangerous mistake. When you are doing a heater installation in your home, always turn off the power and the gas to the unit before you do anything else.
Secure Your Existing Ductwork
There is a chance that the existing ductwork in your home is being supported by your current furnace. If that’s the case, the ductwork could come crashing down when you move your heating unit. This can add several extra hours the job. But if you secure it before moving the furnace, you won’t have to be concerned about that happening. Simple attach it to the ceiling or find something to hold it up while you’re working on replacing the furnace and you can prevent that from happening.
Remove the Furnace Unit
Removing the furnace unit is the halfway point of the process. Disconnect any of the pipes or wires that keep the furnace attached to the home’s structure and move the unit out of the way. You’re not ready for the heater installation in Maple Grove. Reattach all of the pipes, wires and parts to the new heating unit. Then refer to the instructions that came with the unit for starting up the new equipment safely.
